7 mistakes that ruin gasket quality in series production
When gaskets are made by the thousand, a small deviation turns into leaks and returned orders. The 7 most common mistakes and how we prevent them.
Published:

At first sight a gasket is a simple part. But when it is produced by the thousand, even a small deviation turns into a leak, an engine failure and a returned order for the customer. As a manufacturer in series production since 1968, we share the mistakes we see most often and the measures we take.
The 7 most common mistakes
1. Not checking material in every batch
Even from the same supplier, every material batch can differ. Material that goes into production without thickness and hardness checks puts the whole batch at risk.
2. Not monitoring tool wear
As a die wears, hole diameters and edges drift. The first 1,000 pieces are right, the 20,000th is not. Tools must be maintained and measured regularly.
3. Checking only the first piece
Without measurements at set intervals during the run, the error is only noticed at the customer.
4. Wrong thickness on MLS gaskets
The same engine can use several thicknesses such as 0.72 / 0.82 / 0.92 / 1.02 mm. If the thickness marking is mixed up, a gasket that looks right goes to the wrong engine.
5. Defects in coating and sealing beads
If the coating is incomplete or uneven, the gasket can leak in the first hot-cold cycle.
6. Packaging and label mix-ups
If the right gasket goes into a box with the wrong OEM number, the result for the customer is the same as a defect: the wrong part.
7. Final inspection by sampling only
We inspect 100% of our output. Parts we supply to assembly plants go straight to the production line without incoming inspection.

A short checklist for buyers
- Ask for samples before working with a new supplier
- Check the thickness and the OEM number match
- Open and measure a few boxes from the first order
- Ask about the supplier's monthly capacity and lead time
Which gasket problem do you run into most?
Leaks, wrong dimensions, wrong labels... Send us a photo of the problem gasket on WhatsApp and we will look into it.
Write to us on WhatsApp